helpful tip
-
@gloriouscow reminds me of piggybacking ROM/DRAM chips
(you have to have separate CAS/RAS and CS pins, most other are connected 1:1 so its often easier to just lift the few and solder the rest one on another)
@gorplop It's the lazy way to replace a bad DRAM, i've done it
-
Or have the whole thing in backwards...
@futurebird@sauropods.win @gloriouscow@oldbytes.space My usual trick is to carefully pay attention to the notch/dot to ensure that doesn't happen, oblivious to Past Me having failed to be as rigorous when installing the socket.
️ -
@nazokiyoubinbou we've all done it. maybe not three simultaneously - the internally bent pin is particularly nefarious because its hard to see.
@gloriouscow Oof, you're not kidding. I missed it even in the illustration here clearly showing it...
-
@gloriouscow perhaps spin it 180 degrees.
it is a scan from a manual
-
helpful tip
@gloriouscow [chuckles]
-
helpful tip
Oh its ok, that's why there's so many pins.
-
helpful tip
@gloriouscow I felt physical pain seeing this.
-
@gloriouscow I felt physical pain seeing this.
you're welcome
-
helpful tip
@gloriouscow I just know these things demand a blood sacrifice. Poking your finger, ideally under the finger nails or something.
-
helpful tip
@gloriouscow the pin that is fourth from the right, bent outwards: the socket does not have a hole for that pin
the chip installation was doomed to be incorrect -
helpful tip
@gloriouscow that hurts to look at
-
helpful tip
@gloriouscow depends, if you want to alter the functionality of the chip this might be correct.
-
helpful tip
@gloriouscow@oldbytes.space Please CW your gore posts.
-
helpful tip
@gloriouscow so thats why my stuff won't work -
helpful tip
@gloriouscow reminds me of the WOM (write-only memory) data sheet chart of “NUMBER OF INSERTIONS” versus “NUMBER OF INTACT PINS REMAINING”
-
@gloriouscow perhaps spin it 180 degrees.
@adorfer @gloriouscow I’m pretty sure you should.
The indent on the IC should align with on the DIP socket.
-
helpful tip
@gloriouscow Nice illustration but it misses some important details. Mainly, which are the pins that should be bent for correct installation
-
helpful tip
@gloriouscow I’ve been there. Oh yes, I’ve been there #DIP
-
helpful tip
@gloriouscow ouch
-
@futurebird@sauropods.win @gloriouscow@oldbytes.space Needs the off-by-one pin error and the magic smoke escaping to show everything.
@kim
ThisAlso, solder bridges
@futurebird @gloriouscow
