helpful tip

[truh@shark.community]

@gloriouscow I just know these things demand a blood sacrifice. Poking your finger, ideally under the finger nails or something.

[0x7700e6@mastodon.catgirl.cloud]

@gloriouscow the pin that is fourth from the right, bent outwards: the socket does not have a hole for that pin
the chip installation was doomed to be incorrect

[commanderred@chaos.social]

@gloriouscow that hurts to look at

[loganer@mastodon.social]

@gloriouscow depends, if you want to alter the functionality of the chip this might be correct.

[flesh@transfem.social]

@gloriouscow@oldbytes.space Please CW your gore posts.

[mander@corteximplant.net]

@gloriouscow so thats why my stuff won't work

[deltawye@tiggi.es]

@gloriouscow reminds me of the WOM (write-only memory) data sheet chart of “NUMBER OF INSERTIONS” versus “NUMBER OF INTACT PINS REMAINING”

[leckse@social.leckse.net]

@adorfer @gloriouscow I’m pretty sure you should.

The indent on the IC should align with on the DIP socket.

[orva@social.orva.fi]

@gloriouscow Nice illustration but it misses some important details. Mainly, which are the pins that should be bent for correct installation

[galactichero@mindly.social]

@gloriouscow I’ve been there. Oh yes, I’ve been there #DIP

[ciatmusings@raru.re]

@gloriouscow ouch

[delilahtech@tech.lgbt]

@kim
This

Also, solder bridges
@futurebird @gloriouscow

[gloriouscow@oldbytes.space]

OKAY EVERYBODY

since you all liked this post so much and you've all waited so patiently...

Behold.

RAZOR1911-DIP-16-PROPER.RAR

[jfaulken@mastodon.gamedev.place]

@gloriouscow 50 points awarded for the Razor 1911 joke

[kevingranade@mastodon.gamedev.place]

@gloriouscow you're all laughing but chip packages only do this when they're in GREAT DISTRESS!

[starkrg@myside-yourside.net]

@gloriouscow New PCB assembly method idea: DIP staplers. The legs are strong enough to puncture the PCB material, and the legs get folded over the pads on the underside to hold the chip in place which then get little blobs of solder for the electrical connection (or maybe the solder blobs are there already and the legs get heated up by the stapler anvil as they're bent around).