Time to dust off this thread!
-
Pulldown resistors fixed that too!
Next: Fix the broken first row - turns out this was just some broken solder joints. Easy fix. The soldering quality in this display is shockingly poor. But it was a lab / development device after all.
Also gave it a good clean, looks much nicer now!
Now all that's left to do is replace the little potentiometer with a proper brightnes ssensor and wire my board up to the ballasts for dimming.
Sensor put in and wired up. Wiring inside could be nicer, but I'm calling it for now.
-
Sensor put in and wired up. Wiring inside could be nicer, but I'm calling it for now.
Oh I forgot to post here, the display is fully working now, gave is a good clean and all that, ready for the furdance this evening!
I also finished the new split-flap display!
-
Oh I forgot to post here, the display is fully working now, gave is a good clean and all that, ready for the furdance this evening!
I also finished the new split-flap display!
Put in and wired up the address boards and added the units and a bit more stuff that I didn't document but yeah I now have two split-flap displays :3
-
Oh I forgot to post here, the display is fully working now, gave is a good clean and all that, ready for the furdance this evening!
I also finished the new split-flap display!
POV: You're doing on-site hotfixes
-
POV: You're doing on-site hotfixes
@cato love the T-schunk sticker
-
@cato love the T-schunk sticker
@specialflocon hahaha yeah
-
POV: You're doing on-site hotfixes
@cato Please refer to the sticker on the bottom right of your trackpad.
-
@cato Please refer to the sticker on the bottom right of your trackpad.
@techwolf12 awww :3
I did in fact got it -
@techwolf12 awww :3
I did in fact got it@cato Good job
-
POV: You're doing on-site hotfixes
@cato I see a me
-
@cato I see a me
@Thiro yis :3
